diff --git a/docs/me0/run.md b/docs/me0/run.md
index 74666734ab627a7ff0f9fddd9e991dd7f41ba182..b6fd03da5d4888982cfcd74cef41f2c369e52327 100644
--- a/docs/me0/run.md
+++ b/docs/me0/run.md
@@ -94,7 +94,7 @@ Apart from the lines automatically added at the end of the run, you might need t
 ## S-Curve Scan and Trimming
 
 1. In the xDAQ interface (http://pcuclacvp13:20500/), go to "gem calibration Calibration" and select S-Curve Scan.
-2. If you're doing trimming, set trimming source to "Same for all VFAT". You will take 5 total scans over the trimming values {-63,-31,0,31,63}. If not doing trimming, set trimming source to "From Config DB"
+2. If you're doing trimming, set trimming source to "Same for all VFAT". You will take 5 total scans over the trimming values {-63,-31,0,31,63}, which you must manually input for each scan at the bottom of the webpage. If not doing trimming, set trimming source to "From Config DB"
 3. Apply settings in xDAQ and reconfigure. Start the local readout as outlined in the "Data taking" section. Then, hit "Run" in the xDAQ S-curves webpage.
 4. In the terminal with the local readout, you should see Rx begin incrementing after the run is started. When this number stops incrementing (should take 4ish minutes), the run is done.
 5. Once the run is done, stop the local readout with ctrl+C.