diff --git a/Tracker/TrackerDigitization/FaserSCT_Digitization/README.md b/Tracker/TrackerDigitization/FaserSCT_Digitization/README.md
index 4b8569c27c1c856a16724be0014ca3ca7239afd4..00fe54b9373ea5ce184a557ad18f6b2d707f50fe 100644
--- a/Tracker/TrackerDigitization/FaserSCT_Digitization/README.md
+++ b/Tracker/TrackerDigitization/FaserSCT_Digitization/README.md
@@ -1,27 +1,38 @@
 This package will translate Geant4 hits (HITS) into RawDataObject (RDO) data files.
 
-Because input data and alignment is needed, there are a few steps to prepare. From a run directory where calypso is installed, do:
+Because input data and alignment is needed, there are a few steps to prepare. From a run directory where calypso is installed (displayed in the command-line prompt as `run >` below), do:
 
-*) run > ./setup.sh
+```
+run > ./setup.sh
+```
 
 This sets up the runtime environment after building. The "." is mandatory.
 
-*) run > runG4.py >& runG4.log
+```
+run > runG4.py >& runG4.log
+```
 
 This will create a HITS file.
 
-*) run > python python/GeoModelTest/GeoModelTestConfig.py
+```
+run > python python/GeoModelTest/GeoModelTestConfig.py
+```
 
 This will generate a set of neutral alignment data
 
-*) run > CopyAlignFolder.sh
+```
+run > CopyAlignFolder.sh
+```
 
 This will merge the alignment data into the conditions DB.
 
-All the above steps need only be done once after building calypso (but the second and third steps must be repeated each time you do "make install").
+All the above steps need only be done once after building calypso (but the last two steps must be repeated each time you do `make install`).
 
 Now you can run digitization on the HITS file you generated with the command:
 
+```
 run > FaserSCT_DigitizationDbg.py >& digi.log
+```
+
+This will read your `g4.HITS.root` and generate an RDO data file with digitized raw data objects.
 
-This will read your g4.HITS.root generate an RDO data file with digitized raw data objects.