|
|
This page describes the configuration procedures for the supported FPGA boards (KX1, KX2, KC705).
|
|
This page describes the configuration procedures for the supported FPGA boards (KX1, KX2, KC705) and covers these topics:
|
|
|
|
- [JTAG procedure](#General JTAG procedure)
|
|
|
|
- [Temporary configuration](#Temporary configuration)
|
|
|
|
- [Permanent configuration](#Permanent configuration)
|
|
|
|
- [IP address configuration](#IP address configuration)
|
|
|
|
|
|
|
|
#### General procedure
|
|
|
|
|
|
#### General JTAG procedure
|
|
|
The Mercury KX2 board contains a USB-JTAG adapter. To use it, connect a USB 2.0 type B cable to the BDAQ53 base board. Drivers are included in Vivado (the driver can also be [(re)installed](https://www.xilinx.com/support/answers/59128.html) if necessary).
|
|
The Mercury KX2 board contains a USB-JTAG adapter. To use it, connect a USB 2.0 type B cable to the BDAQ53 base board. Drivers are included in Vivado (the driver can also be [(re)installed](https://www.xilinx.com/support/answers/59128.html) if necessary).
|
|
|
If you open the Vivado *hardware manager*, select *open target* and then *auto connect*, the target FPGA will show up.
|
|
If you open the Vivado *hardware manager*, select *open target* and then *auto connect*, the target FPGA will show up.
|
|
|
|
|
|
| ... | |
... | |
| ... | | ... | |
