Hardware/FPGA-configuration.md

@@ -5,6 +5,18 @@ This page describes the configuration procedures for the supported FPGA boards (
 - [IP address configuration](#ip-address-configuration)
 
 
+`ATTENTION`
+--
+The latest Enclustra Mercury KX2 FPGA boards are not configured in JTAG mode by default anymore. The board will be recognized as `FTDI Dual RS232-HS` instead of `Digilent Adept USB Device`.
+
+If this is the case, you need to download the (Windows) program *Enclustra MCT x86* from the tools section of [https://download.enclustra.com](https://download.enclustra.com/).
+
+Fist you need to activate the option **Enable configuring any FTDI** from the *Settings* menu, then click the **Enumerate** button, select the **FTDI 2232H Configuration** *action*, select **Xilinx JTAG** from the *Device mode* drop-down menu and then click the **Set device mode** button. After a few seconds, the board should be successfully set to JTAG mode and recognized as a JTAG interface.
+
+![FTDI](uploads/0d3e5b15b5ec117cf5d35ec344732c14/FTDI.PNG)
+
+---
+
 #### General JTAG procedure
 The Mercury KX2 board contains a USB-JTAG adapter. To use it, connect a USB 2.0 type B cable to the BDAQ53 base board. Drivers are included in Vivado (the driver can also be [(re)installed](https://www.xilinx.com/support/answers/59128.html) if necessary).
 If you open the Vivado *hardware manager*, select *open target* and then *auto connect*, the target FPGA will show up.