Hardware/FPGA-configuration.md

@@ -29,9 +29,12 @@ In many cases it might be more convenient to store the firmware in the flash mem
 *Fig. 2: KC705 boot settings*
 
 2.  Add the correct SPI flash memory device to the Vidado hardware manger by right-clicking the target FPGA and selecting **Add configuration memory**. Based on your hardware, select one of these:
-- BDAQ53 (KX2): **S25FL512S**
-- USBPix3 (KX1): **MT25QL256**
-- KC705 **MT25QL128** if you have a rev. 1.0 board or MR25QL256 for rev. C ([Xilinx Reference](https://www.xilinx.com/support/answers/50079.html)). 
+
+    | Board/FPGA  | Flash Device |
+    | ------------- | ------------- |
+    | BDAQ53 (KX2)  | S25FL512S |
+    | USBPix3 (KX1) | MT25QL256 |
+    | KC705 | MT25QL128|
 
 The memory device now shows up in the target list and you will be asked, if you want to assign a configuration file. 
 
@@ -59,6 +62,7 @@ The IP address can be changed in different ways:
      2. Locate PMOD Pin1 (indicated by a white dot on the PCB).
      3. The IP is set by putting jumpers on the PMOD connector, which short pin 1+2, 3+4, 5+6 and 7+8. Standard binary counting is used:
 
+
         | PMOD_7+8 | PMOD_5+6 | PMOD_3+4 | PMOD_1+2 | IP_ADDRESS    |
         | -------- | -------- | -------- | -------- | ------------- |
         | 0        | 0        | 0        | 0        | 192.168.10.12 |