| ... | ... | @@ -47,20 +47,20 @@ The IP address can be changed in different ways: |
|
|
|
- Jumper settings:
|
|
|
|
The PMOD connector, located between the power connector and the USB port, can be used to configure the IP by soldering a pin header and setting jumpers.
|
|
|
|
|
|
|
|
The default IP address is always 192.168.10.16, but you can change it to .17, .18 or .19.
|
|
|
|
The default IP address is always 192.168.10.16, but you can change it to .11.17, .12.18 or .13.19.
|
|
|
|
|
|
|
|
**Procedure**:
|
|
|
|
1. Make sure, the readout system is not powered.
|
|
|
|
2. Locate PMOD Pin1 (indicated by a white dot on the PCB).
|
|
|
|
3. The IP is set by putting jumpers on the PMOD connector, which short pin 1+3 and/or 5+7.
|
|
|
|
3. The IP is set by putting jumpers on the PMOD connector, which short pin 1+2 and/or 3+4.
|
|
|
|
|
|
|
|
| PMOD_5+7 | PMOD_1+3 | IP_ADDRESS |
|
|
|
|
| PMOD_1+2 | PMOD_3+4 | IP_ADDRESS |
|
|
|
|
| -------- | -------- | ------------- |
|
|
|
|
| 0 | 0 | 192.168.10.16 |
|
|
|
|
| 0 | 1 | 192.168.10.17 |
|
|
|
|
| 1 | 0 | 192.168.10.18 |
|
|
|
|
| 1 | 1 | 192.168.10.19 |
|
|
|
|
|
|
|
|
| 0 | 1 | 192.168.11.17 |
|
|
|
|
| 1 | 0 | 192.168.12.18 |
|
|
|
|
| 1 | 1 | 192.168.13.19 |
|
|
|
|
|
|
|
|
*Fig. 5: BDAQ53 ip setting (example for .19)*
|
|
|
|
4. Double check, that you did not place the jumper in the wrong place!
|
|
|
|
5. Turn the readout system on and ping the new IP address. Then change the parameter `ip` located in the the first section of the `bday53.ymal` configuration file to match the new IP address.
|
| ... | ... | |
| ... | ... | |
