ecal data processor

ecal data processor is implemented. The output port to ethernet need to be set.

common/addr_table/eprocessor.xml

+<node description="EcalDataProcessor Control and Status" fwinfo="endpoint">
+  <node id="DP" address="0x0" description="DataProcessor control and status" fwinfo="endpoint;width=1">   
+    <node id="ctrl" address="0x0" description="control registers">
+      <node id="reset" mask="0x1" description="reset"/>
+      <node id="latency" mask="0x3fe" description="latency"/>
+      <node id="trig_lat_offset" mask="0x7fc00" description="trigger latency offset"/>
+    </node>
+    <node id="stat" address="0x1" description="status">
+      <node id="latency" mask="0x1ff" description="latency"/>
+      <node id="trig_lat_offset" mask="0x3fe00" description="latency"/>
+    </node>
+  </node>
+  <node id="dfilter"  address="0x40"  description="Data filter control and status" fwinfo="endpoint;width=6">
+		 <node id="bypass" address="0x0" mask="0x1" description="bypass zs filter logic"/>
+		 <node id="zs_sc" address="0x1" mode="block" size="32" description="zs filter registers"/>
+  </node>
+    <node id="mon" address="0x80" description="Ecal data monitoring" fwinfo="endpoint;width=2"/>
+</node>